|
1. Remove
any guards or shields covering original material.
2. Tie three
strings provided to bottom seat cover flap. The strings attach to
loops on the flap.
3.
Place bottom seat cover on the seat and align the seam in the seat
cover
with the edge of the seat.
4.
Tuck the flap and three strings between the top and bottom of the seat.
Gather strings and pull tight
5. Feed the
the strings beneath the seat. If there is a wire beneath your seat,
ensure
that the strings go above it and that they do not interfere with the
movement
of the seat.
6. Each string
will attach to a corresponding loop in the front. The easiest way to do
this is to take a string through a loop twice, pull the string tight,
then
make a cinch knot. Repeat for each string. You want to get these as
tight
as possible.
7. Take skirt
string (String that comes attached to cover) below and behind any
mechanisms.
Both sides are brought around to the back where they are tied off tight.
8. Place
Guards and shields back on.
9. If headrests
are present, remove the headrests.
10. Tie three
strings provided to top seat cover. The strings attach to loops
on
the flap.
11. Pull
top cover down tight over the seat.
12. Fold
and tuck the edges .
13.
Feed three strings and the material through between top and bottom of
seat.
14. Pull
each string tight and tie it to its corresponding loop underneath the
material
15. If headrests
were present, replace headrests.
>>back
to top<<
|
